Safety responsibility is weightier than Mount Tai, take a look at the formal company loading machine safety operation specification, using our own have to learn a lesson, safety first!

1, all the departments of the post industry and trade must be after pre tertiary (Department of quality and technology, cement division, section) security, fire training and pass the examination before induction.

2, fork lift truck driver must undergo professional training in operation, structure, performance and work principle of the familiar loader, after passing the examination, certificate holder can be operation of loader.

3, vehicle in the factory when walking, top speed shall not exceed 10 kilometers per hour; may not be speeding fraud overbearing; on other vehicles to avoid each other safely through.

4, vehicle at run time, in addition to loading machine driving indoor dynamic between the arm and the front frame, bucket, a machine cover and any other parts shall be allowed to ride.

5, is strictly prohibited drink posts, or the vehicle to the driver's driving.

6, vehicle at the operation site must pay attention to the safety of the rest of the field staff, safety equipment, forward and backward must look around through the vehicles and pedestrians; and keep a safe distance and the loading and unloading the vehicle.

7, the drivers in each position to discharge industry and trade with the good, when feeding to honk and off to see the grate on whether someone to confirm no feeding.

8, all drivers must always pay attention to safety awareness, in the implementation of a variety of tasks, the task of the drivers of unsafe factors have the right to refuse to do and to reflect the higher.

9, the use of a vehicle, the driver must carefully check the oil level and water cooling and the mechanical connection parts; often check and tighten all screws and nuts; prevent vehicle early wear and damage. To deal with the accident in the bud.

10, the loader bucket should be driving, to maintain position in the transport, which is the bottom of the bucket and the ground distance of about 400mm. Should avoid sudden acceleration, sharp turns, emergency brake and saw tooth shaped driving, etc., to ensure that the load function is stable running.

11, the loader in the downhill, prohibited the engine off coasting in neutral. Otherwise, it will lead to the failure of hydraulic steering, causing major traffic accidents.

12 and loader in the loading and unloading of materials, is strictly prohibited a bias towards one side or bucket lift to the highest position in the material transportation of materials, to ensure the stability, guarantee that the loading machine safety driving.

13, loading machine pick up before, around the body should be straight, on and near the stock pile. At the same time, the bucket parallel contact with the ground, and then pick up.

14 and take the goods to according to the resistance of the material, selects the appropriate gear and speed, bucket into the stock pile, improve boom. At the same time, the bucket is backward, the body to move forward.

15, loading machine operation should comply with the following six are not allowed":

Don't use the high speed pickup;

The side edge to not pick up;

Not allowed elevated bucket driving;

The transverse slope on the road are not allowed to travel in;

The bucket no emphasis on driving;

The no maintenance in the raised bucket or stand under.

- from Tiebi brothers

Shandong Shan Yu Heavy Machinery Co., Ltd.